Nearly all of the time, companies would spend lots of money to purchase their forklifts. It is vital, therefore to take good care of your machine to protect your investment into the long run. It is a good idea to know the procedures that are carried out in the maintenance and care of this piece of machine.
One of the best ways to tell how good the engine is running is by starting the lift truck up and listening closely to see how it runs. For instance, if there are any misses or knocks, the machine is faulty and this should raise several concerns. Additionally listen carefully for any squealing sounds that come from the belts as these noises would provide you with a wealth of information.
When performing maintenance, several of the main parts you would need to pay attention to comprise the safety warning devices, horn, gauges, the overhead guard and the lights. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to check the wiring.
The battery compartment terminals must be cleaned after the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Each and every battery cell should be checked in order to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and then change the filters. The transmission filter, fuel filters and the hydraulic filter must be frequently replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
Once the oil change has been carried out and new filters have been fitted, visually check the drive axle from underneath the machine. Be certain to grease the axle if there is any grease fitting. Check the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, check each and every other component of the machine like the wheels. If any type of fault or issue is detected, be sure to address it immediately so as to make sure the equipment is working at its safest and optimum levels.